A-TAK

One component, thin liquid that is low hazard and is non-flammable.

Most uncured Urethanes and Epoxies can be cleaned up with A-TAK.

Prolonged immersion and/or heat may be required for some cured polymers.

Physical Properties

Viscosity @ 25°C	20 cps
Color	Clear
Flammability	Non-flammable

DIRECTIONS FOR USE

Cured Polymer – Immerse in A-TAK until soft or dissolved. Accelerate with heat, up to 150°F, if necessary.

Uncured Polymer – Wipe with a clean rag soaked with A-TAK. Test A-TAK on non-critical areas FIRST, before use. A-TAK may effect other areas; paint, etc.

STORAGE:
These polymer systems have a minimum shelf life of six months when unopened. Products should be stored off the floor at table height, in a room temperature environment. When not in use, containers should be kept tightly closed.

PRECAUTIONS:
Skin or eye contact with polymers should be avoided. The use of gloves and eye protection are strongly recommended. All polymers, as a general practice, should be used in well-ventilated areas. Spot ventilation is most effective. Contaminated clothing should be removed immediately and the skin washed with soap and water or waterless skin cleaner. Should accidental eye contact occur, wash thoroughly with water and consult a physician.