|
Easy to use Non-transferable
Good for all epoxies urethanes and
polymer alloys
-
Hard,
paste wax, release agent which has been specifically formulated to release
epoxies, urethanes, and other polymer alloys.
-
Depending on the surface finish
required, you can apply GREASES IT WAX P with a cloth, wipe, or a brush.
Apply in multiple coats, allowing to dry between each coat.
-
May be buffed between coats to
achieve the most accurate transfer of detail.
-
Designed to be used with GREASE IT
TWO, a film forming release, when a 2 step release system is required.
|
Typical Properties
|
Type
|
Paste wax |
|
Viscosity
|
Paste |
|
Dry time between coats |
5 minutes |
|
Number of coats
|
2-4 |
|
Color
|
Tan
|
|
Specific Gravity
|
.08
|
|
|
Directions For Use
APPLICATION TECHNIQUE:
BRUSH / WIPE
-
Apply multiple coats, allowing to dry between coats and
buff if required.
-
Use a cloth wipe or brush to apply.
-
The use of a hair dryer to accelerate
drying time is recommended.
STORAGE:
These polymer
systems have a minimum shelf life of six months when unopened. Components should
be stored in a cool dry place. When not in use, containers should be kept
tightly closed.
PRECAUTIONS:
Skin or eye contact
with polymers should be avoided. Clean housekeeping procedures are urged and the
use of gloves and/or protective creams suggested. All polymers, as a general
practice, should be used in well-ventilated areas.
Spot ventilation is most effective. Contaminated clothing should be removed
immediately and the skin washed with soap and water or waterless skin cleaner.
Should accidental eye contact occur, wash thoroughly with water and consult a
physician.
|
|
